81 lines
3.4 KiB
Plaintext
81 lines
3.4 KiB
Plaintext
IrcVPN - Irc Virtual Public Network
|
|
===================================
|
|
This is an ethernet tunnel providing basic hubbed or switchet networks via irc.
|
|
|
|
Warning: If you use this software on a "real" (read: not your own) network:
|
|
1. You might run into various flood protections
|
|
2. Your IRC-OP might kill you for that
|
|
|
|
Furthermore: All of your data will go kind-of plaintext over an Irc-channel.
|
|
While this is a rather uncommon way of ip transit, everybody who
|
|
is able to join the channel might be able to eavesdrop.
|
|
|
|
|
|
Installation and requirements
|
|
=============================
|
|
* python-irclib
|
|
* ether2any
|
|
|
|
For configuration take a look at conf.py, it has some comments to give you a
|
|
hint of what this switch will do. Some of the security settings are rather
|
|
untested, keep that in mind. After configuration, start the tunnel with
|
|
python ircvpn.py. A tap-device will open and the tunnel should be ready to run.
|
|
|
|
|
|
What it does and how it works
|
|
=============================
|
|
IrcVPN uses an ircchannel as its transport medium. When starting this tunnel,
|
|
it makes a connection to the configured irc-server, joins a channel and starts
|
|
pushing all outgoing network traffic (base64 encoded with a small header) to
|
|
that channel. The nick will be a combination of the configured prefix and
|
|
the TAP interfaces mac-address.
|
|
|
|
There are two network-modes available:
|
|
|
|
.Hubbed Network
|
|
In a hubbed network topology all the clients share one broadcast medium, the
|
|
irc channel.
|
|
|
|
.Switchet Network
|
|
In a switched network topology still all the clients join the irc channel and
|
|
use it for broadcast messages but unicast traffic goes directly to the user
|
|
it is intended for, as it is sent to the nickprefix-macaddress combination.
|
|
Wether the user with the specific mac actually IS in the network is not
|
|
checked.
|
|
|
|
Flood protection is kind of the biggest issue for irc as ether: After a
|
|
configured amount of messages most irc-servers queue the incoming messages
|
|
and send them out as one per second. If the send-queue is overflowed the user
|
|
gets kicked from the server. So this tunnel is not going to perform very well
|
|
on normal servers out there. Setting up an own server, the flood protection CAN
|
|
be turned off but irc-server with configurable flood protections tend to allow
|
|
flooding only in channels and only if the user is either voiced, half-op or op.
|
|
This is where voicebot.py comes in: The voicebot voices everyone who joins the
|
|
channel and utters a certain phrase. Therefore it is kind of ensured that every
|
|
bot has the right to flood the ether as much as it wants with network packets.
|
|
|
|
Ircs right management can always be used to mute, rate-limit or remove spamming
|
|
or otherwise unwanted clients.
|
|
|
|
|
|
Header Format
|
|
=============
|
|
<fragmentation flag><packet id> <base64 encoded message>
|
|
|
|
The *fragmentation flag* can be either of o, b, c, e. *o* stands for oneliner,
|
|
which means that afterwards there is a complete ethernet frame (no
|
|
fragmentation). *b*, *c*, *e* stand for begin, continue, end and mark packets
|
|
which are broken into several pieces (as of irc does not support infinit line
|
|
length).
|
|
|
|
The packet id is just a randon generated number between 0, 99999 (incl.).
|
|
|
|
|
|
What could be done
|
|
==================
|
|
* replace base64 with something more fitting for Irc
|
|
* test security settings
|
|
* find static linkable irc server, patch flood protection out of it
|
|
* VVLAN - a Virtual VLAN between irc-channels/servers
|
|
|